GENERAL INFORMATION
A generously-sized round table, featuring a central base reminiscent of the cactus from which it takes its name. it consists of six curved, wedge-shaped, panels, applied protruding over the central plinth. The wooden panels are 3d printed. The top has a rounded edge divided into four wedges that create an interesting geometric pattern. All chipboard panels conform to EN 120 - Class E1. All parts in wood (heartwood or veneer) are painted or varnished in an opaque, transparent, polyurethanic or acrylic finish. Used in the production of panels are borders in wood, polyestered and melaminic. Products used for varnishing or painting contain no formaldehyde, their composition being such that they are classified non-toxic. These products are free, moreover, of the heavy metals mentioned in European specification EN71, part 3, 1988.
USE AND MAINTENANCE
The product is destined for use inside homes as a place to set lightweight objects. The table top is not to be considered as a worktop of any type. Do not sit on the top or stand on it with your feet. Do not place heavy objects on the table that could damage it or cause it to tip over. Load weight uniformly. Avoid performing maintenance on components of the table. Call the dealer if necessary. Avoid allowing water and other liquids to remain in contact with the surface, even for short periods of time. The edges must not be placed near heat sources warmer than 45°C. The presence of particular odours emitted from the product when the packaging is removed is not hazardous and disappears gradually as the room is aired out. The cement grout finish is created with a manual process, and due to its particular nature, there may be differences in finish and shade of the colour. These differences are not to b considered defects; they are the proof of a fine artisan procedure.
WARNING:
GIVEN THE WEIGHT OF THIS TABLE, WE ADVISE ASSEMBLING IT ONLY AFTER DECIDING ON ITS FINAL POSITION. TO MOVE THIS TABLE, GRASP THE TOP AS CLOSE TO THE BASE AS POSSIBLE AND LIFT SLIGHTLY. DO NOT ROLL OR TIP THE TABLE; MOVE IT WITH THE TOP IN A HORIZONTAL.
MAINTENANCE OF WOOD PARTS
For everyday maintenance dust with a soft dry cloth. For greasy, oily marks (fingerprints) we advise cleaning the surface with alcohol diluted in water, drying immediately with a soft cloth. Products containing acetone, bleach and solvents should be avoided, as should abrasive products, furniture wax and hard fibre cloths (linen and synthetics) which could ruin and/or scratch surfaces. All these operations should be carried out with great care, avoiding heavy pressure. Exposure to direct sunlight can alter the wood colour.
MAINTENANCE OF CEMENT GROUT FINISH
For normal maintenance, use a soft cloth to remove dust and dry residue. For more stubborn dry dirt (dust that penetrates in the porous surface), we advise using a compact weave or sponge cloth, slightly damp with warm water and well squeezed out. Wipe in the direction of the grain of the table top without using excessive pressure. For oily residue and fingerprints, we advise treating the surface with a damp sponge. Use water and neutral non-foaming detergent and then wipe the surfaces again as described above. Never use products that contain acetone, ammonia, chlorine and solvents, or abrasive products.
DISPOSAL
Once discarded, neither the product nor its components should be dispersed in the environment, but rather consigned to public disposal systems.
0%