GENERAL INFORMATION
A series of tables that stand out for the base’s tent-like structure which uses an innovative mix of cement and fibre. This material permits the creation of complex shapes combining resistance and elasticity with innovative concepts such as the fact that the material can be totally recycled and its manufacture is of low environmental impact.
The company reserves the right to make changes to the models.
USE AND MAINTENANCE
The product is designed for domestic use to support lightweight material; the table tops are not to be used in any way as work benches; do not climb up and do not seat on the table; avoid any type of bump against the parts in crystal: do not overload the ends with weights which may result in damage or overturning; avoid maintenance work on table components and always contact your dealer for any problem; any smells the product gives off as soon as it is unwrapped are not dangerous and disappear with exposure to a ventilated area.
Warning: when moving the table grip and raise the base. The table must not be raised by the glass top.
MAINTENANCE OF PARTS IN GLASS
For everyday maintenance dust with a soft dry cloth. For greasy, oily marks (fingerprints) we advise cleaning the surface with alcohol diluted in water, drying immediately with a soft cloth. For glass, specific products readily available on the market can be used. Hard fibre cloths (linen and synthetics) which could ruin and/or scratch the varnish are to be avoided.
MAINTENANCE OF PARTS IN CEMENT
As regards normal maintenance, dust and dry residues, use a soft cloth. For stubborn dry dirt (dust which has penetrated into the porosity of the granite) it is advisable to use a close-knitted or a spongy cloth, slightly dampened with warm water and well wrung out, without applying too much pressure. As for both greasy and oily marks (fingerprints) it is recommended to treat the surfaces with a small sponge dampened with water and neutral liquid detergent. Afterwards go over the surfaces once again as described above. Products which contain solvents and/or methylated spirits as well as cloths with rigid fibres (linen and synthetic fibres) are to be avoided as these may ruin the varnish. Imperfections (holes, streaks of colour) on the lower part of the base are typical of the material and its production method (pour moulding) and therefore should not be considered defects.
MAINTENANCE OF MARBLE TOP
As regards normal maintenance, dust and dry residues, use a soft cloth. For stubborn dry dirt (dust which has penetrated into the porosity of the granite) it is advisable to use a close-knitted or a spongy cloth, slightly dampened with warm water and well wrung out. Clean by following the vein of the surface without applying too much pressure. As for both greasy and oily marks (fingerprints) it is recommended to treat the surfaces with a small sponge dampened with water and washing-up liquid. Afterwards go over the surfaces once again as described above. Products which contain solvents and/or methylated spirits as well as cloths with rigid fibres (linen and synthetic fibres) are to be avoided as these may ruin the varnish. Given the kind of treatment it is important to immediately remove stains following the above described procedures.
DISPOSAL
Once discarded, neither the product nor its components should be dispersed in the environment, but rather consigned to public disposal systems.
0%
